Contactors KNL6 - KNL30

KNL22









  • Contactors are used for switching electric motors and other resistive inductive and capacitive loads

  • A wide variety of snap-on auxiliary switch blocks and accessories

  • Uniform marking of connection terminals in accordance with EN 50005 and EN 50011

  • Quick assembly to a 35 mm wide mounting rail in accordance with EN 60715 or fixing with screws

  • Open and funnel-shaped connection terminals – fast and simple connection

  • Plus/minus screws, protected against falling out – standard or posidrive screwdrivers can be used

  • High contact reliability at low voltages

  • Possibility of individual marking on a special plate – easy identification of a contactor in the circuit

  • Auxiliary contact with a pushbutton function

  • Uniform contactor width – 45 mm

  • Assembly to vertical or horizontal surface with ±20° deviation

  • Third coil terminal

  • Possibility of direct connection of a bimetal relay for protection against overload and in case of phase failure

  • Version with all four main contacts (Sp4) (KNL9 - KNL18)

  • Degree of protection IP20

  • High electrical and mechanical endurance, and high switching capacity



Documentation

Data sheets:
Catalogue pages
Catalogue pages (in Italian language)
Catalogue pages (in Spanish language)
Catalogue pages (in Russian language)
Catalogue pages (in Serbian language)

Declaration of Conformity:  
KNL6-KNL30 EC Declaration of Conformity
GOST-R Certificate (in Russian language)

You must be registered in order to see the above documents.